The STREAMER water cutter is designed for cutting soft materials such as rubber, cork, foams or plastics without the use of abrasive. Provides high cutting precision and minimal gap. It can be used, among others, in the rubber industry, advertising industry, modeling industry, or in companies producing printing dies.
| Width | 1000 mm |
| Length | 1000 – 2000 mm |
| Travel speed | 10 m/min |
| Operating pressure | 2000 bar |
Solutions that you receive as standard:
Low costs
The cost of one hour of operation of the device is estimated to be less than 4 PLN and less than 20 PLN for the abrasive version. This is the result of an innovative high pressure system that provides exceptional efficiency. The average energy consumption is only 3.5 kW per hour and the water consumption does not exceed 3 l / min. The Streamer water cutter is also low investment costs – it is almost twice cheaper than other waterjet cutters.
Reliable compact
The device is a compact, robust design of small size. The high pressure system installed in the device was developed and built by our experienced engineering staff, so it does not require frequent and costly servicing. Installing a water conditioner and appropriate filters will ensure many years of trouble-free operation.
Simple installation
The device only requires an electrical connection, access to running water, a drain and a small amount of compressed air. If required, an optional compressor can be mounted inside the housing.
Versatility
The device is perfect for cutting soft materials such as cork, rubber, foam or soft plastics with clean water. It is very easy to increase the range of materials to be cut using the abrasive (abrasive) cutting attachment. Then cutting aluminum, steel, stone, glaze or terracotta is possible.
Additional options available:
Contact us
Do you have questions or are interested in the product and would like to receive an offer? Call us on +48 730 850 710, +48 570 740 950 or fill out the form below.
